Black & Decker CM1936Z Assembling the Grass Catcher Figures E1, E2, E3, E4, Grassbag Frame Clip

ASSEMBLING THE GRASS CATCHER (FIGURES E1, E2, E3, E4)
1.	Before starting to assemble the grass bag to the frame, check that the grass bag and frame are similar to figure E1.
2.	Slide the grass bag onto the frame as shown in figure E2.
3.	Assemble the top clips to the frame as shown in figure E3, then assemble the two side clips and the bottom clip last.	E2
4.	E1
	Completely assembled grass catcher is shown in figure E4.

GRASSBAG

FRAME

CLIP

WHEEL HEIGHT ADJUSTMENT (1-1/2 IN. (38mm) TO 3-1/2 IN. (89mm) FIGURES F, G

NOTE: Certain types of grass or grass conditions may require varying the height of the mower deck. Grasses of mature lawns often are seriously injured when mowed shorter than 1-1/2 inches (38mm), and a height of 1-1/2 to 2 inches (38mm) to (51mm) is preferred on large lawns.

1. Before making any adjustments, release bail handle to turn mower off, wait for blade to stop, and remove safety key.

2. Your mower features the Black & Decker one touch wheel height adjustment system. This system will adjust all four wheels at the same time.

3. To raise or lower the cutting height, place the palm of your hand on the palm rest F-1and with your fingers, squeeze upward on the finger grip F-2and hold.

4. While holding the finger grip up you can raise or lower the cutting height. The mower has seven blade height adjustment positions. Refer to the scale G-1and pointer G-2at the rear of the mower. The pointer will indicate the height setting for cutting your lawn.

This setting can be a reference for the next time you want to cut your lawn at the same height.

When you have the mower at the height you would like, hold it in place with your left hand on the lower right handle bar and release the finger grip with your right hand to lock the height adjust. Note: To ensure that the deck is securely locked in one of the seven positions, press down on the palm rest after releasing the finger grip.

F	1
	2
1	2
7