Black & Decker SPCM1936 Batteryruntime Indicator Figure H, Removing Battery from Mower Figure

Page 8

BATTERY

 

 

 

CAUTION: USE ONLY BLACK & DECKER APPROVED REPLACEMENT BATTERIES - CONTACT YOUR LOCAL SERVICE CENTER

OR 1-800-544-6986.

 

 

The battery is a 36-volt sealed lead acid system. There is no liquid contained within the battery and the mower/battery can therefore be stored in

any position without fear of leakage.

 

IT IS RECOMMENDED THAT THE BATTERY BE RECHARGED AFTER USE TO PROLONG THE BATTERY LIFE. FREQUENT CHARGING

WILL NOT HARM YOUR BATTERY, AND WILL ENSURE THAT THE BATTERY IS FULLY CHARGED AND READY FOR ITS NEXT USE.

STORING BATTERY NOT FULLY CHARGED WILL SHORTEN BATTERY LIFE. REFER TO OFF-SEASON STORAGE SECTION.

For optimal performance the battery should be kept on constant charge when not in use.

 

The battery should be charged in its proper orientation.

 

The battery prefers to be charged in a cool, dry place.

 

The battery does not need to be fully discharged before recharging.

 

2 to 3 initial charging cycles may be required after purchase to achieve maximum run time capacity.

 

A fully charged battery can be safely stored down to -40°C (-40°F).

 

The battery is maintenance free.

 

The CM1936Z can use either the RB3610 or RB3612 battery. The RB3612 battery is for use with the SPCM1936 mower only. The battery

 

should not be used for any other purpose.

 

BATTERYRUNTIME INDICATOR - FIGURE H

 

Your battery pack is equipped with an integral Battery Runtime Indicator.

 

When you push the "i" button H-1, the indicator will give the battery

1

runtime level.

 

At full charge, if you push the "i" button, all three LED's will light up

 

indicating maximum runtime.

 

If you want to check the runtime during your cutting:

 

1.

Release bail handle to turn mower off, wait until the blade stops and

 

2.

remove safety key.

 

 

Push the "i" button to get an indication of runtime.

 

All three LED's lit indicate maximum runtime available.

 

Two LED's lit indicate approximately one-third to two-thirds of runtime

 

available.

 

 

One LED lit indicates less than one-third runtime available. You may need

 

to charge your battery soon. Refer to Charging Procedure.

 

REMOVING BATTERY FROM MOWER - FIGURE I

 

The battery can be removed from the mower for storage/charging or left

 

in the mower for charging.

place mower on level ground.

 

Prior to removing battery,

 

Release bail handle to turn mower off, wait for blade to stop, and remove

 

safety key.

 

 

To remove the battery, lift the lever I-1, and then rotate back away from

 

battery pack to unlatch clasp I-2. Lift battery pack out.

 

Prior to the installation of the battery pack, ensure that the mower is clear

 

of debris and the charger plug is disconnected from the battery pack.

 

CHARGER SAFETY RULES

 

1.

Plug charger directly into an electrical outlet. DO NOT ABUSE THE

 

 

CORD. Never carry charger by cord. Do not disconnect the charger

 

2.

from the outlet, mower or battery by pulling it by the cord.

 

WARNING: To reduce the risk of fire, electrical shock, or

 

 

personal injury do not attempt to use this charger with any other

 

 

product. Likewise, do not attempt to charge the battery with any other

 

3.

charger.

 

 

Do not service mower with charger, safety key or battery pack installed.

 

4.

Do not operate a damaged charger. Replace damaged cords or

 

5.

charger immediately at an authorized Black & Decker service center.

 

Always charge the mower in a dry area protected from the weather.

 

 

Do not expose the mower, battery or charger to rain. Do not charge in

 

 

wet locations. Do not charge battery when temperature is above 104°F (40°C) or below 41°F (5°C). Remove battery and charge indoors if

 

above or below these temperatures. Charge the battery in a well

 

6.

ventilated location.

 

 

Keep the mower, battery and charger away from water, heat sources, (such as radiators, heaters, stoves, etc.) flames, or chemicals. Be

7.

careful not to damage the charger cord, by keeping cord away from sharp edges.

 

Prior to reinstalling the battery into the mower, disconnect charger plug from battery, or damage may occur.

 

 

WARNING: FIRE HAZARD

 

ALWAYSDISCONNECT THE CHARGER FROM THE POWER SUPPLY (WALL OUTLET) BEFORE REMOVING THE CHARGER CONNECTOR. UNDER CERTAIN CONDITIONS, WITH THE CHARGER PLUGGED IN TO THE POWER SUPPLY,THE EXPOSED CONNECTOR CAN BE SHORTED BY FOREIGN MATERIAL AND MAY CAUSE A FIRE.

FOREIGN MATERIALS OF A CONDUCTIVE NATURE, SUCH AS, BUT NOT LIMITED TO, STEEL WOOL, ALUMINUM FOIL, OR ANY BUILD-UP OF METALLIC PARTICLES, SHOULD BE KEPT FROM THE CONNECTOR. ALWAYSUNPLUG CHARGER BEFORE ATTEMPTING TO CLEAN.

8

Image 8
Contents VEA EL Español EN LA Contraportada Please Read Before Returning this Product for ANY ReasonKEY Information YOU should Know Read ALL Instructions To Reduce Risk of InjuryUSE of Extension Cords Volts310 Functional Description CM1936ZFunctional Description SPCM1936 Assembly Handle Assemblyfigure CHandle Adjustment Figure D PreparationAssembling the Grass Catcher Figures E1, E2, E3, E4 Grassbag Frame ClipBattery Batteryruntime Indicator Figure HRemoving Battery from Mower Figure Charger Safety RulesCharging PROCEDURE- Figures J, K, L Know Your Mower Safety KEYON-OFF Switch Bail Handle Figure M Meets Cpsc Safety RequirementsTo Turn Mower on Variable Speed Self Drive System Figure NInstalling Mulch Insert Figure P Installing Grass Catcher Figure Q, RFor Models Without ON-DEMAND Removing Mulch Insert Figure O Operatingthe Mower for DischargingDischarge Mode Bagging ModeYour mower is now in Bagging mode Mulching Mode For Models with ON-DEMANDMaintenance Removing and Installing Blade Figure UMulching Mowing Tips 19mm wrench U-2 as shown in figure UCleaning Blade SharpeningBlade Balancing LubricationOFF-SEASON Storage Battery Service and InstallationStorage Position Troubleshooting Guide Problem SolutionWarranties Center for ServicingGuide DʼUTILISATION Lire Toutes CES Directives Conserver CES Mesures Utilisation DE Rallonges Description Fonctionnelle CM1936Z Description Fonctionnelle SPCM1936 Préparation AssemblageDéballage Illustrations A, B Ensemble DE Poignée Figure CMontage DU Collecteur Dherbe Illustrations E1, E2, E3 ET E4 Pile Retrait DE LA Pile DE LA Tondeuse IllustrationRègles DE Sécurité Pour LE Chargeur Avec Lecentre DE Réparation DE Votre Région OU Composer LELire LE Mode Demploi ET LES Règles DE Sécurité Avant FonctionnementProcédure DE CHARGE- ILLUSTRATIONSJ, K, L Connaître SA TondeuseDémarrage DE LA Tondeuse Interrupteur DE MARCHE/ARRÊT Anse Illustration MSPCM1936 Seulement Surcharge DE LA TondeuseInstallation DE LA Pièce DE Déchiquetage Tondre EN Mode DéjectionInstallation DU Collecteur Dherbe Pour LES Modèles Sans « Sélection DEPour LES Modèles Avec « Sélection DE Mode » Mode déjectionMode densachage Mode de déchiquetageConseils Pour LE Déchiquetage EntretienConseils Pour Tondre LA Pelouse Retrait ET Installation DE LA Lame Illustration U Affûtage DE LA LameLors DE Laffûtage DE LA Lame Affûtage DE LA Lame Dans UN ÉtauÉquilibrage DE LA Lame NettoyagePrévention DE LA Corrosion Transport ET RangementEntretien ET Installation DE LA Pile Rangement Hors SaisonLE Sceau Srprc Recyclage DES Piles Rechargeables 800Problème Solution Coupe inégale et une décharge rapide de la batterieRemarque Page Manual DE Instrucciones Pautas DE SEGURIDAD/DEFINICIONES Page USO DE Cables Prolongadores Volts Longitud total del cable en piesDescripción DE LAS Funciones CM1936Z Descripción DE LAS Funciones SPCM1936 Preparación EnsamblajeDesembalaje Figuras A, A1, A2 Ensamblaje DEL Mango Figura CEnsamblado DEL Recolector DE Césped Figuras E1, E2, E3, E4 Batería Indicador DE Duración DE LA BateríaRetiro DE LA Batería DE LA Podadora Normas DE Seguridad DEL CargadorLlave DE Seguridad Procedimiento DE Carga Figura J, K, LConozca LA Podadora Para Encender LA Podadora SPCM1936 ÚnicamenteSobrecarga DE LA Podadora Cumple CON LOS Requisitos DE Seguridad DE LA CpscProtector DE Seguridad Y Puerta Trasera Figura O Para Modelos SIN Operación SegúnInstalación DE LA Pieza Para Mantillo Figura Operación DE LA Podadora Para DescargaPara Modelos CON Operación Según Requerimiento Modo de descargaModo de recolección en bolsa Modo de formación de mantilloConsejos Para EL Corte DE Césped Para Formar Mantillo MantenimientoConsejos Para EL Corte DE Césped Retiro E Instalación DE LA Hoja Figura U Afilado DE LA HojaAL Afilar LA Hoja Para Afilar LA Hoja EN UNA PrensaSimetría DE LA Hoja LubricaciónLimpieza Prevención DE LA CorrosiónMantenimiento E Instalación DE LA Batería EL Sello Rbrc Reciclado DE BateríasGarantías Garantía en la cubiertaGuía DE Solución DE Problemas Problema SoluciónProblema Product Infomation · Identificación DEL ProductoSolamente Para Propositos DE Mexico Años DE GarantiaEsta Garantia no Aplica Cuando

CM1936Z, SPCM1936 specifications

The Black & Decker SPCM1936, also known as the CM1936Z, represents a standout choice in the realm of cordless lawn mowers, combining innovation with user-friendly design to deliver efficient lawn care. This model is powered by a robust 36V lithium-ion battery, which offers ample runtime to handle medium to large-sized yards without the nuisance of cords or gas.

One of the primary features of the SPCM1936 is its lightweight construction, making it easy to maneuver across various terrains. Weighing significantly less than many traditional gas mowers, the SPCM1936 allows users to navigate tight spaces and intricate landscaping effortlessly.

The mower comes equipped with a 19-inch cutting deck, striking a balance between agility and the ability to cover large areas quickly. The deck material is designed to be durable yet lightweight, ensuring longevity and ease of use. This model offers a 6-position height adjustment feature, allowing users to customize their mowing height from 1-inch to 3-inches, giving flexibility for different grass types and seasonal changes.

Technology is at the forefront of the Black & Decker SPCM1936's design. It boasts a Smart Cut technology, which automatically adjusts the power of the motor based on the thickness of the grass being cut. This ensures optimal performance while conserving battery life, enhancing efficiency and extending the runtime during use.

Another critical feature is the mower's EdgeMax design, which allows the blade to cut closer to edges and flower beds, reducing the need for trim work and making the mowing process quicker and less labor-intensive. The mower also features a bagging system that collects grass clippings, promoting cleaner yard maintenance, while its mulching capability returns nutrients back to the soil.

The SPCM1936 is designed with user comfort in mind, featuring an easy-to-handle ergonomic grip and a foldable handle for convenient storage. With safety features like a safety key and a blade brake, users can operate the mower with peace of mind.

In summary, the Black & Decker SPCM1936, CM1936Z is an advanced, efficient, and user-friendly cordless lawn mower, perfect for homeowners seeking reliability and ease in lawn maintenance. Its combination of power, innovative technology, and smart design makes it a top contender in the cordless mower market.