3 Configuring the Switch

•Autonegotiation – Shows if auto-negotiation is enabled for disabled. (This setting is fixed at “Disabled” for all 10G ports.)

•Trunk Member8 – Shows if port is a trunk member.

•Creation9 – Shows if a trunk is manually configured or dynamically set via LACP.

Web – Click Port, Port Information or Trunk Information.

Figure 3-52 Port - Port Information

Field Attributes (CLI)

Basic information:

•Port type – Indicates the port type. (10G or 100-TX)

•MAC address – The physical layer address for this port. (To access this item on the web, see “Setting the Switch’s IP Address” on page 3-13.)

Configuration:

•Name – Interface label.

•Port admin – Shows if the interface is enabled or disabled (i.e., up or down).

•Speed-duplex – Shows the current speed and duplex mode. (Auto, or fixed choice)

•Capabilities – Specifies the capabilities to be advertised for a port during auto-negotiation. (To access this item on the web, see “Configuring Interface Connections” on page 3-48.) The following capabilities are supported.

•10half - Supports 10 Mbps half-duplex operation

•10full - Supports 10 Mbps full-duplex operation

•100half - Supports 100 Mbps half-duplex operation

•100full - Supports 100 Mbps full-duplex operation

•10Gfull - Supports 10 Gbps full-duplex operation

•Broadcast storm – Shows if broadcast storm control is enabled or disabled.

•Broadcast storm limit – Shows the broadcast storm threshold. (500 - 262143 packets per second)

8.Port Information only.

9.Trunk Information only.

3-86