System Management Commands 4

Example

Console(config)#enable password level 15 0 admin

Console(config)#

Related Commands

enable (4-19) authentication enable (4-70)

IP Filter Commands

Table 4-11 IP Filter Commands

Command

Function

Mode

Page

 

 

 

 

management

Configures IP addresses that are allowed management access

GC

4-27

 

 

 

 

show management

Displays the switch to be monitored or configured from a browser

PE

4-28

 

 

 

 

management

This command specifies the client IP addresses that are allowed management access to the switch through various protocols. Use the no form to restore the default setting.

Syntax

[no] management {all-client http-client snmp-client telnet-client} start-address[end-address]

•all-client - Adds IP address(es) to the SNMP, web and Telnet groups.

•http-client - Adds IP address(es) to the web group.

•snmp-client - Adds IP address(es) to the SNMP group.

•telnet-client - Adds IP address(es) to the Telnet group.

•start-address- A single IP address, or the starting address of a range.

•end-address- The end address of a range.

Default Setting

All addresses

Command Mode

Global Configuration

Command Usage

•If anyone tries to access a management interface on the switch from an invalid address, the switch will reject the connection, enter an event message in the system log, and send a trap message to the trap manager.

•IP address can be configured for SNMP, web and Telnet access respectively. Each of these groups can include up to five different sets of addresses, either individual addresses or address ranges.

4-27