3 Configuring the Switch

Web – Click Port, Port Broadcast Control or Trunk Broadcast Control. Check the Enabled box for any interface, set the threshold, and click Apply.

Figure 3-60 Port Broadcast Control

CLI – Specify any interface, and then enter the threshold. The following disables broadcast storm control for port 1, and then sets broadcast suppression at 6000 packets per second for port 2.

Console(config)#interface ethernet 1/1

4-125

Console(config-if)#no switchport broadcast

4-129

Console(config-if)#exit

 

 

Console(config)#interface ethernet 1/2

 

Console(config-if)#switchport broadcast packet-rate 6000

4-129

Console(config-if)#end

 

 

Console#show interfaces switchport ethernet 1/2

4-132

Information of Eth 1/2

 

 

Broadcast Threshold:

Enabled, 6000 packets/second

 

LACP Status:

Enabled

 

Ingress Rate Limit:

Disabled, 10000M bits per second

 

Egress Rate Limit:

Disabled, 10000M bits per second

 

VLAN Membership Mode:

Hybrid

 

Ingress Rule:

Disabled

 

Acceptable Frame Type:

All frames

 

Native VLAN:

1

 

Priority for Untagged Traffic:

0

 

GVRP Status:

Disabled

 

Allowed VLAN:

1(u),

 

Forbidden VLAN:

 

 

Console#

 

 

 

 

 

3-102