Line Commands 4

Command Usage

Set the speed to match the baud rate of the device connected to the serial port. Some baud rates available on devices connected to the port might not be supported. The system indicates if the speed you selected is not supported. If you select the “auto” option, the switch will automatically detect the baud rate configured on the attached terminal, and adjust the speed accordingly.

Example

To specify 57600 bps, enter this command:

Console(config-line)#speed 57600

Console(config-line)#

stopbits

This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default setting.

Syntax

stopbits {1 2}

•1 - One stop bit

•2 - Two stop bits

Default Setting

1 stop bit

Command Mode

Line Configuration

Example

To specify 2 stop bits, enter this command:

Console(config-line)#stopbits 2

Console(config-line)#

disconnect

This command terminates an SSH, Telnet, or console connection.

Syntax

disconnect session-id

session-id– The session identifier for an SSH, Telnet or console connection. (Range: 0-4)

Command Mode

Privileged Exec

Command Usage

Specifying session identifier “0” will disconnect the console connection. Specifying any other identifiers for an active session will disconnect an SSH or Telnet connection.

4-17