4 Command Line Interface

Related Commands

snmp-server location (4-114)

snmp-server location

This command sets the system location string. Use the no form to remove the location string.

Syntax

snmp-server location text no snmp-server location

text - String that describes the system location. (Maximum length: 255 characters)

Default Setting

None

Command Mode

Global Configuration

Example

Console(config)#snmp-server location WC-19

Console(config)#

Related Commands

snmp-server contact (4-113)

snmp-server host

This command specifies the recipient of a Simple Network Management Protocol notification operation. Use the no form to remove the specified host.

Syntax

snmp-server host host-addr[inform [retry retries timeout seconds]] community-string[version {1 2c 3 {auth noauth priv} [udp-port port]}

no snmp-server host host-addr

•host-addr- Internet address of the host (the targeted recipient). (Maximum host addresses: 5 trap destination IP address entries)

•inform - Notifications are sent as inform messages. Note that this option is only available for version 2c and 3 hosts. (Default: traps are used)

-retries - The maximum number of times to resend an inform message if the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)

-seconds - The number of seconds to wait for an acknowledgment before resending an inform message. (Range: 0-2147483647 centiseconds; Default: 1500 centiseconds)

•community-string- Password-like community string sent with the notification operation to SNMP V1 and V2c hosts. Although you can set this string using the snmp-server host command by itself, we recommend that you define this string using the snmp-server community command prior

4-114