ADIC FileServ Version 4.0 600716 Rev A manual Remove Media, Add Blank Media

		AdministrativeTasks
Remove Media	Step 1.	Run the fsmedout command with the media
		identifiers and the -roption for the media to be
		checked out. The -tlabeltext option is not supported
		at this time.
	Step 2.	The physical location of the media (-llocation) is
		used for tracking the media and is limited to 255
		characters.
		Media are logically checked out of the FileServ
		system.
	Step 3.	Contact the VolServ operator to complete the
		operation and to obtain the media.
Add Blank Media	FileServ uses the fsmedin -bcommand to logically enter
	blank media into FileServ software.

Note

For more information on the fsmedin command, refer to the

Command Reference book.

Blank media can be added to the general blank pool or to a specific DataClass group pool. Blank media in the general blank pool are available for use in any DataClass group. Blank media in the DataClass group pool are only available for use by that particular DataClass group.

The quantity of media being added can be optionally entered as an argument of the fsmedin -bcommand. The quantity option is primarily used when a specific number, less than the value specified by the system VS_DEF_QUANTITY parameter, is needed.

Operaitng Tasks

600716 Rev A Operating Tasks 2-57