Aga Ranges U110054 manual Main Top, Control Panel and Oven Doors, Self-Clean Oven

Fig.6-5

Fig.6-6

Fig.6-7

Fig.6-8

Main Top

Lift away pots or pans from the main top. Remove the grates from the spillage area and carefully place in a sink of warm soapy water. Wipe loose debris from the main top. For best results use a liquid detergent cleaner. Rinse with cold water and thoroughly dry with a clean, soft cloth. Ensure all parts are dry before repositioning.

Avoid using any abrasive cleaners including cream cleaners on brushed stainless steel surfaces.

Never use caustic or abrasive cleaners as these will damage the surface.

Control Panel and Oven Doors

The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water – but take care that no surplus water seeps into the appliance. Wipe with a clean dampened cloth then polish with a dry cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water.

Removing the oven door outer panel

The outer door panel can be removed so that the inside of the glass can be cleaned. Undo the 4 screws (2 each side) in the door (Fig.6-5). Open the door slightly and, using the handle, carefully lift the door outer upwards.

Refit in reverse.

Self-Clean Oven

 WARNING!

Remove all cookware, racks, and the rack supports from the oven before using the self-clean function. If the racks and supports are left in the oven they will discolor and become rough.

	 WARNING!
Fig.6-9	Remove the divider before using the self-clean
	function. See page 10, ‘Removing the divider’.

 DO NOT clean the door gasket: the door gasket is essential for a good seal. Care should be taken not to rub, damage or move the gasket.

 DO NOT use oven cleaners: no commercial oven cleaner or oven liner protective coating of any kind should be used in or around any part of the oven.

 Clean only part listed in this User Guide.

DO NOT use the oven light while in self-cleaning mode.

To remove and refit the racks

The rack has a small kink on either side. To remove the rack, line these up with the stops in the rack support (Fig.6-6). Lift the rack upwards so that it will pass over the rack stop and then pull it forwards (Fig.6-7).

Refit in the reverse order, making sure to push it fully back.

20