3-39
Eye-Diagram Analyzer Reference
Saving to Mass Storage
To Change a
Memory Card
Battery
The memory card’s battery is a lithium commercial CMOS type, part num ber
CR 2016.
The memory card should be installed when the battery is removed. If the b at-
tery is removed while the card is not installed, all data in the card will be lost.
Store memory-card files on another device before changing the battery, when
extra care is appropriate.
1Install the memory card into the 70004A display.
2On the front edge of the card, locate the groove of the battery clip.
3Gently pry the battery clip out of the card. The battery fits inside th e c l ip.
4Replace the battery, making sure the plus (+) sign on the battery i s on the same
side as the plus sign on the clip.
5Insert the battery clip into the memory card, holding the clip as oriented in the
figure. (Face the open edge of the clip toward the memory car d’s write-protect
switch.)
6Write the date the battery was replaced on the card.