1-19
Getting Started
Steps for Setting Up Eye-Diagram Analysis
Step 3. Complete the Installation Using the Screen Instructions •If the displayed screen looks like the figure o n the left side of this page, your
system has been previously configured. Press CONT and then con tinue with
"Step 4. Connect the front-panel cables". However, if you wish to reconfigure
your system, press RECNFIG, and continue with the following expl anation of
the self-guided screens.
•If the screen looks like the figure on the right side of this page, the first self-
guided screen is displayed. Perform the following steps:
1Press 7084X if you are using an 70841A/B pattern generator. If using an
70843A, or any other pattern generator, press MANUAL.
2If you press 7084X, the screen shown on the following page is displayed. The
program automatically determines and displays the pattern gene rator module’s
HP-MSIB address. For most installations, press CONT. To manua ll y enter the
HP-MSIB address, use the displayed softkeys.
Example of a Configuration Previously Done