Searching for a station, zone or remote site from the list
ASearching for a station or zone in your site by entering the name [NAME SEARCH]
1Select [NAME SEARCH] either in the standby mode (→P. 28) or the SEARCH LIST (→P. 29).
2Enter a name by using the dial keys. (→P. 40)
e.g.)
When searching for "MASTER004"; Press the dial keys as follows.
|
|
|
|
| (4 times) |
|
| (twice) (3 times) (8 times) (8 times) (4 times) | ||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
M A |
| S | T |
| E | R | 0 | 0 | 4 |
| ||||||||||||||||
The entered characters are displayed here.
All the station and/or zone names that include the entered characters in your site are displayed in the list.
*The search is narrowed down whenever a character is added.
NOTE: |
|
You can also select a station from the list by using | after |
you select [NAME SEARCH] in step 1. |
|
To delete the just entered character:
Press 
.
To enter the same characters or characters on the same dial key sequentially:
(e.g.: To enter “AB”)
1.Enter “A”. (Press the dial 
key once.)
2.Press 
.
3.Enter “B”. (Press the dial 
key twice.)
3 Press 
to select the target station or zone (so that it is highlighted) from the list.
*You can select up to 5 stations and/or zones if [ADD/ RMV] is displayed on the screen. (See below.)
4 Start calling (talking), monitoring or paging by following the procedure for the corresponding performance. (→P.
To select two or more stations and/or zones from the
list: (When 
(Add/Remove) is displayed on the screen)
1)Press LIST as 
with the target station or zone highlighted.
The station or zone is checked.
*Press LIST as 
again to clear the check.
2)Repeat step 1) to select more stations and/or zones.
*You can select up to 5 stations and/or zones.
To select 5 stations and/or zones, after checking 4 stations and/or zones, select the 5th one so that it is highlighted. (The 5th station or zone is not checked.)
*You cannot select two or more remote sites.
30
