Aiphone IS operation manual Calling another station direct voice call

Calling another station (direct voice call)

Follow the steps below to call a desired door station, room sub station, master station in your site, or a remote site.

1 Search for and select the station or remote site you want to call (so that it is highlighted) in one of the search methods. (→P. 28-34)

*If you call (the pilot station in) a remote site by searching for it from [REMOTE SITE] of SEARCH LIST, select the target site, and then select [CALL] (so that it is highlighted). (→P. 32)

Refer to the on-screen instructions:

Be sure to make operations by checking the information on the upper part of the monitor. The next operations you can perform are displayed.

e.g.)

[] TALK … You can start talking by pressing TALK or lifting the handset.

*If you will not set the priority, it is set to “Normal”.

[] MONI … You can start monitoring by pressing

MONITOR .

[ ] PR (or PRIORITY)

………You can proceed to the priority setting mode by pressing ZOOM/WIDE .

2 To set the priority, press ZOOM/WIDE , and then

press to select the target priority (so that it is highlighted).

*If you will not set the priority, skip this step and press TALK or lift the handset. You can start calling (talking).

3 Press TALK or ZOOM/WIDE or lift the handset to start calling (talking).

or

or

When a tone rings, your voice is heard at the target station and you can also hear sounds at the target station. (Direct voice call)

The receiver can answer the call without pressing any button or lifting the handset. (Talk back)

*If the target station is a master station, the response of it differs from the PRIVACY MODE setting on the target station. (See the table below.)

PRIVACY MODE
setting on the target		Response
master station
	Your voice is heard at the target
OFF	station and you can also hear sounds
	at the target station.
	Communication is enabled when the
1	receiver presses		TALK		or lifts the
	handset. Otherwise you can hear no
	sound from the target station.
	When the target station receives your
	call, a tone notifies you that the target
	station is in the (PRIVACY MODE) 2.
	Communication is enabled when the
2	receiver presses		TALK		or lifts the
	handset. Otherwise you can hear no
	sound from the target station.
	* You can adjust the volume of call
	tone from [RECEIVE VOL] by
	pressing	SETTING		.

4 Press OFF or hang up the handset to finish communicating.

GETTING STARTED SETTING AND ADJUSTMENT USING THE SYSTEM

APPENDIX

35