Wireless Broadband Router User Manual
the Wireless Broadband Router how to direct traffic across networks.
Item | Description |
Outbound Protocol | Specifies the protocol the application |
| uses. TCP or UDP |
|
|
Outbound Port | Enter the WAN port range from which |
Start/End | data that follows that particular protocol |
| should be sent. |
|
|
Inbound Protocol | Select the protocol (UDP or TCP) for the |
| port. |
|
|
Inbound Port | Enter the WAN port range from which |
Start/End | data that follows that particular protocol |
| will return. |
|
|
To Port Start/End | Enter the LAN port range. |
|
|
Enabled | Select this option and click Apply to |
| activate the configuration. |
|
|
uStatic Routes
In this section, the user can define static routes for incoming packets. To define a static route, enter the following information:
Item | Description |
IP Address | Enter the network address of the destination |
| computer. |
|
|
Subnet | Enter the subnet mask of the destination computer’ s |
Mask | network address |
|
|
Gateway | Enter the router’ s IP for the destination computer. |
|
|
Metric | Enter the number of transmission hops (range 0 ~ |
| 15). |
|
|
Interface | Select whether the destination computer is located on |
| the WAN or LAN interface. |
|
|
44
