Wireless Broadband Router User Manual
uLAN MAC Filter
LAN MAC Filter Mode: This filter mode is based on the MAC address of client computers. By default, this feature is disabled. To activate this function, select:
∙Allow: Requests from computers with matching MAC address specified in the LAN MAC Filters table is allowed to pass through the WAN port.
∙Deny: Requests from computers with matching MAC address specified in the LAN MAC Filters table is NOT allowed to pass through the WAN port.
LAN MAC Filters: Enter the MAC address of the computer(s) (e.g. 00:90:96:12:13:14) in the table. To find the MAC address of the client computers, see the section “Viewing Current DHCP Assignments (Router Mode Only)” on page 30.
uLAN Client Filter
LAN Client Filters: The filter mode is based on the IP address of the client’ s computers. Enter the following information:
LabelDescription
LAN IP Address Range The range of IP addresses of the LAN machines from which packets will be affected.
Protocol | Select TCP or UDP. For example, if FTP |
| services shall be blocked, then select |
| TCP. |
Destination Port Range Specifies the start and the end of the Port range that shall be blocked. For example, 21 ~ 21 blocks FTP services. Clients cannot access any application from this port.
From Day / To Day | Select the days of the week this filter shall |
| apply. |
|
|
From Hour / To Hour | Select the hours of the day this filter shall |
| apply. |
|
|
41
