Part 2. Configuring protocol-specific settings | Airlink RT210W

Wireless Broadband Router User Manual

3.Host Name: If required, enter a host name for this router. Some ISPs only respond to a DHCP request with a valid “Host Name” . If a host name is not necessary for your ISP/network environment, just leave it blank.

Figure 4-4 WAN Configuration – General

Part 2. Configuring protocol-specific settings

According to the Protocol selected above, enter the related parameters.

uDHCP Client

If DHCP Client is your option, no other configuration is needed. You may just click Apply to end your WAN settings. After the connection with the ISP is established, the information provided by the ISP will be displayed in the Status section.

Figure 4-5 WAN Configuration – DHCP Client

uPPPoE Client

Theses parameters are provided by the Internet Service Provider.

24

Image 34

Airlink RT210W user manual Part 2. Configuring protocol-specific settings, Dhcp Client, PPPoE Client

Contents

Page Disclaimer Trademarks Safety Instructions For Service FCC Information Page Contents Troubleshooting Specification Appendix a List of Figures Page Introduction Overview Features ∙ NAT Package Contents System RequirementsPage Physical Outlook LED IndicatorFront Panel Rear Panel and Connector Rear Panel and Connector Choosing a Place for the Wireless Broadband Router Hardware Connection Connecting Cable/ADSL Modem to the WAN port Connecting the Wireless Broadband RouterConnecting wired device to the LAN port Connecting the power adapter Figure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router For Windows 98/ME Setting up TCP/IPOption a Using Dhcp Control Panel ∙ On the IP Address tab, select Specify an IP address Option B Using Fixed IP Address192.168.1.1 For Windows 2000/XP Check/Renew IP Address under Windows 98/ME ∙ Default Gateway Select Use the following IP address and enter these ∙ Authentication Open Additional Settings for Wireless ClientCheck/Renew IP Address under Windows 2000/XP Checking Connection with the Wireless Broadband Router For example C\ping Request time out Destination host unreachable Web Configuration Accessing Web-Based Configuration Utility Making the Changes Effective Applying Changes System Overview Router Mode General Information System Overview Bridge Mode WAN Configuration Router Mode Part 1 Configuring general settings Dhcp Client Part 2. Configuring protocol-specific settingsPPPoE Client WAN Configuration PPPoE Client WAN Configuration Bridge Mode Manual Config Enabling Bridging Mode LAN Configuration Dhcp Server Router Mode Only LAN Spanning Tree Protocol Router Mode Only LAN Configuration Router Mode Viewing Current Dhcp Assignments Router Mode Only 11 Dhcp Lease Table Wireless LAN 2.4G Configuration Basic Configuration Wireless Bridge 12 Access Point Mode 13 Wireless Bridge Mode Access Control Advanced ConfigurationPage Wireless LAN Security Network Authentication WEP Format Minimum CharactersNetwork Key fields Key Length HEX Format Ascii Format 64 Bit Hexadecimal digits Ascii characters 128 Bit 15 Wireless LAN Security General Filters Router Mode OnlyConnection Logging LAN MAC Filter LAN Client Filter Forwarding Router Mode Only 16 Filters Description DMZ IP AddressPort Forwards Application Specific Port Forwards Static Routes Administration System Clock Management Setup Firmware Upgrade Current Firmware version field Restore Factory DefaultsSystem Page Troubleshooting Page Interface Power Adapter and Environmental RequirementHardware Physical Router Features WAN Port FeaturesLAN Port Features Software Wireless LAN Features Security FeaturesConfiguration and Management Features Technical Support