Administration, System Clock | Airlink RT210W manual

Wireless Broadband Router User Manual

Figure 4-17 Forwarding

5.0 Administration

This page allows the administrator to perform the following settings:

uSystem Clock

Network administrators may synchronize date and time among network devices by synchronizing the local clock to an available NTP (Network Time Protocol) server.

NTP Server: Enter IP address of the NTP server. Up to three entries are allowed.

Time Zone: From the drop-down menu, select a time zone according to your geographic location.

45

Image 55

Airlink RT210W user manual Administration, System Clock

Contents

Page Trademarks Disclaimer Safety Instructions For Service FCC Information Page Contents Appendix a Troubleshooting Specification List of Figures Page Overview Introduction ∙ NAT Features System Requirements Package ContentsPage Physical Outlook LED IndicatorFront Panel Rear Panel and Connector Rear Panel and Connector Hardware Connection Choosing a Place for the Wireless Broadband Router Connecting the power adapter Connecting the Wireless Broadband RouterConnecting wired device to the LAN port Connecting Cable/ADSL Modem to the WAN port Figure below illustrates a connection diagram example Page Configuring Local Computer to Access the Wireless Router Control Panel Setting up TCP/IPOption a Using Dhcp For Windows 98/ME ∙ On the IP Address tab, select Specify an IP address Option B Using Fixed IP Address192.168.1.1 Check/Renew IP Address under Windows 98/ME For Windows 2000/XP Select Use the following IP address and enter these ∙ Default Gateway ∙ Authentication Open Additional Settings for Wireless ClientCheck/Renew IP Address under Windows 2000/XP For example C\ping Checking Connection with the Wireless Broadband Router Request time out Destination host unreachable Accessing Web-Based Configuration Utility Web Configuration Applying Changes Making the Changes Effective General Information System Overview Router Mode System Overview Bridge Mode Part 1 Configuring general settings WAN Configuration Router Mode Dhcp Client Part 2. Configuring protocol-specific settingsPPPoE Client WAN Configuration PPPoE Client Manual Config WAN Configuration Bridge Mode Enabling Bridging Mode Dhcp Server Router Mode Only LAN Configuration LAN Configuration Router Mode LAN Spanning Tree Protocol Router Mode Only 11 Dhcp Lease Table Viewing Current Dhcp Assignments Router Mode Only Basic Configuration Wireless LAN 2.4G Configuration 12 Access Point Mode Wireless Bridge 13 Wireless Bridge Mode Advanced Configuration Access ControlPage Network Authentication Wireless LAN Security WEP Format Minimum CharactersNetwork Key fields 64 Bit Hexadecimal digits Ascii characters 128 Bit Key Length HEX Format Ascii Format 15 Wireless LAN Security General Filters Router Mode OnlyConnection Logging LAN Client Filter LAN MAC Filter 16 Filters Forwarding Router Mode Only Application Specific Port Forwards DMZ IP AddressPort Forwards Description Static Routes System Clock Administration Firmware Upgrade Management Setup Current Firmware version field Restore Factory DefaultsSystem Page Troubleshooting Page Physical Power Adapter and Environmental RequirementHardware Interface Software WAN Port FeaturesLAN Port Features Router Features Wireless LAN Features Security FeaturesConfiguration and Management Features Technical Support