MAINTENANCE

ASSEMBLY INSTRUCTIONS FOR GEARBOX

Step 1. Install bearing cups into lower end of main housing. Using appropriate tool, install first cup, then spacer, and then last cup. Note: Apply Locktite #270 to cups before installing. Note direction of cups when installing. See crossection view Figure Mnt-R-0127.

Step 2. Apply Locktite #270 to cone bore and press bearing cone on output shaft against shoulder at lower end. Insert shaft assembly into bottom of main housing. Install top bearing inserting over end shaft inside main gearbox housing. Install gear spacer. Install Gear Adjusting Shims, if any were present at disassembly. Install the Output Gear on the Output Shaft. Figure Mnt-R-0128.

Step 3. Install special flat washers and special lock washer. Apply locktite to nut threads and threads on shaft.

Figure Mnt-R-0129.

A96B 03/06

Maintenance Section 5-21

© 2006 Alamo Group Inc.

MAINTENANCE

Page 163
Image 163
Alamo 00761808C, A96B, FC-0015, FC-0016 manual Assembly Instructions for Gearbox, Figure Mnt-R-0129