MAINTENANCE
MAINTENANCE
Disassembly and Assembly Procedures for T-BOX
Refer to Figure
Remove Main Input Shaft
Step I.
Drain oil from gearbox. Place gearbox on appropriate work surface. Remove 8 bolts retaining input housing hub. Remove hub assembly from main housing. Note Quantity and thickness of shims between hub and main housing.
Step II.
Remove cotter pin (14) and adjusting nut (13).
Step III.
Remove gear (17). Press on threaded end of shaft (16) to remove from hub.
Step IV.
Press bearing cone (8) from shaft (16).
Step V.
Remove bearing cups (8) from hub housing.
Step VI.
Remove 8 bolts (10) from one side cap (2). Tap on opposite side shaft end (6) to remove side cap (2) and on side shaft assembly.
Step VII.
Remove 8 bolts retaining remaining side cap (2) in place. Using end of hammer handle tap inside of cap to remove from main housing. Note quantity and thickness of shims under both side caps.
Also mark side cap which was closest to gear and main housing, so it may be reassembled later in same location.
Step VIII.
Lap shaft ends on solid metal surface to remove bearings (8), gear (3), and spacer (4).
Gearbox is now completely disassembled. Inspect and replace all worn or damaged parts.
A96B 03/06 | Maintenance Section |
© 2006 Alamo Group Inc.
