
MAINTENANCE
Step 5 Place output cap on the output shaft and check the gap between housing and cap to see how many gaskets will be required. Remove the output cap and install the gaskets. A small bead of sealant should be applied on top of the gaskets and around the flange of the cap. Reinstall the cap and gasket assembly on the Housing, install the 4 Bolts and tighten them to a torque of 75 to 79 Foot Pounds. Figure
Step 6 Install rear input shaft bearing cup in back side of main housing.
Step 7 Install Bearing on the Input Shaft and then place Shaft into the Housing. Next install the Gear Spacer on the Shaft. Reinstall the Gear Adjusting Shims on Shaft and the Input Gear. Check the back side of the Gear Tooth surface where the Input and Output Gear engage each other. These two surfaces should be approximately flush. If they are not approximately flush, then either add or subtract shims under the output Gear or in front of Input Gear. Figure
A96B 03/06 | Maintenance Section |
© 2006 Alamo Group Inc.