ASSEMBLY

WHEELS - PULL TYPE

Install the Wheels on the Wheel Hubs. Note: If Laminated Tires are used, place the flat side of the Lug Nut

against the Wheel Figure ASM-R-0146.Note direction of travel and curvature of rubber segments in tire and install as shown in Figure ASM-R-0146.

DRIVELINE ATTACHMENT

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a

shield. (Figure ASM-R-0118)

1.Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque. Refer to Torque Chart in Maintenance Section.

A96B 03/06

Assembly Section 3-9

© 2006 Alamo Group Inc.

ASSEMBLY

Page 93
Image 93
Alamo FC-0015, A96B, FC-0016, 00761808C manual Wheels Pull Type, Driveline Attachment