Amana ZRRC8000, ZRTC8500 Electronic Oven Control Options, Special Oven Control Functions

Electronic Oven Control

AMHR

PM

CLEAN OVEN

:

	°	ER 3 5 0
		P
		CONV BROIL PRE-
		DELAY TIMED BAKE
STOP ON TIMER		CLEAN LOCK ON

BAKE

Electronic Oven Control Options

PANEL LIGHT—Used to light backguard and illuminate cooking surface.

OVEN LIGHT—Used to light inside of oven. Brightens oven cavity when oven door is opened or panel switch is turned on.

MINUTE TIMER—Use to time any kitchen function or cancel timer.

STOP TIME — Use to set delayed bake and delayed self clean.

CLOCK — Use to set time of day.

OVEN CANCEL — Cancel any cooking or cleaning function.

COOK TIME — Use to set timed or delayed cooking.

BAKE — Use to set bake.

INSTA-BROIL— Use to set broil.

CONV BAKE — Use to set convection bake.

CONV — Use to set convection.

CONV BROIL — Use to set convection broil.

CLEAN — Use to set self-clean.

+ or - — Use to select temperature or time.

Special Oven Control Functions

Preheat Signal

After setting oven to cook and selecting a temperature, oven will preheat. When the oven reaches the set temperature, a 1-second signal will sound.

End-of-Cycle Signal

When a timed cycle is complete, three long signals will sound. End of cycle signal will continue to sound until CANCEL is touched.

Child Lockout

This is a safety feature used to prevent children from accidentally programing oven. It disables electronic oven control. Touch and hold BAKE and COOK TIME for 5 seconds. “OFF” will display where the temperature normally appears. To reactivate control, touch and hold BAKE and COOK TIME for 5 seconds. Child lockout feature must be reset after a power failure.

12 Hour Automatic Cancel

This is a safety feature that prevents oven from continuing to operate if it has been left on for over 12-hours. If a cooking function continues longer that 12-hours without any options on oven control being touched, this feature turns oven off. Any time an option is touched, 12-hour automatic cancel is reset.

Minute timer Signal

When time elapses, minute timer beeps 3 times then once every 10 seconds. If MINUTE TIMER end-of-cycle signal is sounding, touch MINUTE TIMER.

Increasing + or - Pad Speed

When setting time and temperature, hold pad to accelerate rate at which numbers increase or decrease.

Self-diagnostic System

Electronic range control has a self-diagnostic system. Self-diagnostic system sounds a series of short, rapid beeps and shows a "F-code" in display when there is a problem.

10