Replacing Panel Light Bulb
1.Lift up on front edge of backguard top trim. Flip top trim towards rear of backguard.
2.Twist fluorescent bulb to remove it from sockets.
CAUTION
Wear gloves to protect hands from accidental bulb breakage.
Lift
Removing Storage Drawer
1.Slide drawer out until it stops.
2.Grasp drawer sides near back of drawer.
3.Lift up and out.
• Reverse to reinstall.
Removing Coil Surface Elements
WARNING
To avoid risk of personal injury, do not touch surface elements or area near elements without checking for heat. Surface elements may be dark in color even when hot. Hold hand above surface element to detect heat before touching. Areas near elements may be hot enough to burn.
1.Hold hand above surface element to detect heat before touching. Do not touch if heat is detected.
2.Grasp element at end opposite from receptacle and lift approximately an inch.
• Element clip holds surface element in place.
3.Pull surface element out of receptacle and set aside.
4.Reverse procedure to reassemble.
S u rfa c e E le m e n t | |
| B u rn e r B o w l |
C lip | R e c e p ta c le |
23
