Minimum Clearances to Combustible Surfaces
•Minimum clearance to rear wall is 0 inches.
•Minimum clearance to a vertical right or left side wall is 0 inches.
•Minimum clearance to counter top/cabinet on each side is 0 inches.
•Minimum of 30 inches (76.2cm) between top of cooking surface and bottom of an unprotected wood or metal cabinet.
•24 inches between cooking surface and protected wood or metal cabinet above range. Cabinet bottom must be protected by at least ¼ inch thick millboard with not less than No. 28 MSG sheet steel, .015 inch thick stainless steel, .024 inch thick copper.
A
C
B
D
E
Irregular Cabinet and Counter Top Heights
Counter tops such as ceramic tile tops can cause cabinet and counter top to be higher than 36 inches (91.4cm). Follow instructions below when counter top is higher than 36 inches (91.4cm).
1.Raise leveling legs to maximum level.
2.Measure from floor to range top. If measurement is less than height of counter top floor must be shimmed.
3.Shim floor using a piece of plywood same size as range opening. Secure plywood to floor. Plywood must be as secure as original flooring.
4.Install
• See
Line Voltage Requirements
Line voltage must not exceed rated voltage. Line voltage less than rated voltage will result in slow heating. Wiring system must conform to C.S.A standards and Canadian Electrical
This range requires 4 wires, 120/240 Volts, 60 Hertz A.C. See rating plate attached to range for kilowatt rating. House wiring and fusing must comply with local wiring codes. If no codes apply, wire according to Canadian Electrical
Power Supply Location
Shaded areas show range clearance for electrical connection. Power cord is supplied with range.
A
B
C
D
6
