Operation: Set Up the Display
Pressure units. Set the units of measure for pressure readings and settings to either English (psig) or metric (kPa).
Adjust display
Path: Main > Setup > System # > Display > Display Adjust
Set the LCD contrast. Adjust the visibility of the screen text. Lower numbered settings provide darker text; higher numbers provide lighter text. Settings range from
Key Click. Enable or disable a beep sound every time a key is pressed on the display interface.
How to update the firmware
Path: Main > Setup > System # > Display > Update Firmware
To update the controller firmware:
1.Go to www.apc.com/tools/download/ and check for the most recent version of the firmware.
2.If a newer version is available, download it to a location that can be accessed in step 4.
Stop the System before updating the firmware. For instructions, see “Stop the
System” on page 5.
3.Set up the serial connection:
a.Connect an available serial port of your computer to the
b.Run a terminal emulation program, such as HyperTerminal®.
c.Configure the following settings on the serial port you selected:
Baud Rate | 19200 |
Data Bits | 8 |
Parity | None |
Stop Bits | 1 |
Flow Control | None |
Some terminal emulation programs require that you disconnect and then reconnect the terminal session for the new serial port settings to take effect.
Note
4.On the display interface, Select YES from the Update Firmware menu. Use the path you selected in step 2.
32 | NetworkAIR IR Operation, Maintenance, and Troubleshooting |