How to Recover From a Lost Password
You can use a local computer, a computer that connects to the Network Management Card or other device through the serial port to access the control console.
1.Select a serial port at the local computer, and disable any service that uses that port.
2.Use the configuration cable
Do not touch components on the electrical panel, other than the serial port.
3.Run a terminal program (such as HyperTerminal®) and configure the selected port as follows:
–2400 bps
–8 data bits
–no parity
–1 stop bit
–no flow control.
4.Press ENTER, repeatedly if necessary, to display the User Name prompt. If you are unable to display the User Name prompt, verify the following:
–The serial port is not in use by another application.
–The terminal settings are correct as specified in step 3.
–The correct cable is being used as specified in step 2.
5.Press the Reset button on the faceplate of the NetworkAIR IR
6.Press ENTER as many times as necessary to
7.From the Control Console menu, select System, then User Manager.
8.Select Administrator, and change the User Name and Password settings, both of which are now defined as apc.
9.Press
Do not touch components on the electrical panel, other than the serial port.
NetworkAIR IR Operation, Maintenance, and Troubleshooting | 57 |