AMX Mio Modero R-4 manual Raising and lowering the LCD brightness, Setting the Home Hold Time

Device Setup Pages

Make sure to adjust the Sleep Timeout period after disengaging the Sleep on Display Timeout function. From the factory, the default sleep timeout will be set for 15 minutes, but engaging and then disengaging the Sleep on Display Timeout function will reset the period for 0 minutes (will not sleep until the battery charge runs low) because the previous setting will already have 0 for that setting, even though it was not actually used.

5.Select the Back button until you are out of the Setup Menu.

While deactivating the Sleep on Display Timeout function will prevent the Mio R-4 from going offline when the selected Display Timeout time is reached, doing so will decrease the effective battery life. Setting the Sleep Timeout period to 0 will keep the device from disconnecting from the network, but even a fully charged battery will reach a very low point within 10 to 14 hours. If the device’s battery is too depleted, it may need to be returned to the charging cradle and recharged before it can be used again.

Raising and lowering the LCD brightness

1.Select Remote & Display Settings from the Setup Page.

2.Under LCD, use the Up/Down arrows to adjust the LCD brightness in one-point increments, from a minimum of 0 to a maximum of 100.

Take care not to set the LCD brightness too low, as the screen may become too dark to read. If you accidentally set the LCD brightness too low and the screen becomes too dark, touch the center right of the touchscreen until the screen brightens again.

3.Select the Back button until you are out of the Setup Menu.

Raising and lowering the charge LED brightness

1.Select Remote & Display Settings from the Setup Page.

2.Under Charge LED, use the Up/Down arrows to adjust the LED brightness in one-point increments, to a minimum of 0 and a maximum of 100.

3.Select the Back button until you are out of the Setup Menu.

Setting the Home Hold Time

1.Select Remote & Display Settings from the Setup Page.

2.Under Home Hold Time, use the Up/Down arrows to adjust the home hold time in one-second increments, to a maximum of 6.

A setting of 0 has special meaning: it disables the "home" function on buttol hold, allowing the back/home button to operate like other external buttons.

3.Select the Back button until you are out of the Setup Menu.

Changing the remote inactivity page flip

1.Select Remote & Display Settings from the Setup Page.

2.Under Inactivity, use the Up/Down arrows to adjust the page flip time in increments, to a maximum of 240.

3.Select the Back button until you are out of the Setup Menu.

Mio Modero R-4 13