AMX Mio Modero R-4 manual @Ppt, @Ppx, @Pse, @Psp, @Pst

	Programming the Mio R-4
Page Commands (Cont.)
@PPT	Set a specific popup page to timeout within a specified time. Timeout is in 1/10 seconds. If
Set a popup page	timeout is empty, popup page will clear the timeout.
to timeout within a	Syntax:
specified time	SEND_COMMAND <DEV>,"'@PPT-<popup page name>;<timeout>'"
	Variables:
	• popup page name = 1 - 50 ASCII characters. Name of the popup page.
	• timeout = timeout duration in 1/10ths of a second.
	Example:
	SEND_COMMAND Device,"'@PPT-Popup1;30'"
	Sets the popup page 'Popup1' to timeout within 3 seconds.
@PPX	Close all popups on all pages. This command works in the same way as the 'Clear All'
Close all popups	command in TPDesign4.
on all pages	Syntax:
	SEND_COMMAND <DEV>,"'@PPX'"
	Example:
	SEND_COMMAND Panel,"'@PPX'"
	Close all popups on all pages.
@PSE	Set the show effect for the specified popup page to the named show effect.
Set the show	Syntax:
effect for a popup	SEND_COMMAND <DEV>,"'@PSE-<popup page name>;<show effect name>'"
page
	Variables:
	• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
	On.
	• show effect name = Refers to the popup effect name being used.
	Example:
	SEND_COMMAND Device,"'@PSE-Popup1;Slide from Left'"
	Sets the Popup1 show effect name to 'Slide from Left'.
@PSP	Set the show effect position. Only 1 coordinate is ever needed for an effect, however the
Set the show	command will specify both. This command sets the location at which the effect will begin
	at.
effect position
	Syntax:
	SEND_COMMAND <DEV>,"'@PSP-<popup page name>;<x coordinate>,<y
	coordinate>'"
	Variable:
	• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
	On.
	Example:
	SEND_COMMAND Device,"'@PSP-Popup1;100,0'"
	Sets the Popup1 show effect x-coordinate value to 100 and the y-coordinate value to 0.
@PST	Set the show effect time for the specified popup page.
Set the show	Syntax:
effect time for a	SEND_COMMAND <DEV>,"'@PST-<popup page name>;<show effect time>'"
popup page
	Variables:
	• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
	On.
	• show effect time = Given in 1/10ths of a second.
	Example:
	SEND_COMMAND Device,"'@PST-Popup1;50'"
	Sets the Popup1 show effect time to 5 seconds.

Mio Modero R-4 45