Programming the Mio R-4

"^" Button Commands with Embedded Codes

These Button Commands are used in the NetLinx protocol and are case insensitive.

All commands that begin with "^" have the capability of assigning a variable text address range and button state range. A device must first be defined in the NetLinx programming language with values for the Device: Port: System (in all programming examples - Remote is used in place of these values).

Variable text ranges allow you to target 1 or more variable text channels in a single command.

Button State ranges allow you to target 1 or more states of a variable text button with a single command.

The "." Character is used for the 'through' notation, also the "&" character is used for the 'And' notation.

"^" Button Commands with Embedded Codes

^BMF

Set any/all button parameters by sending embedded codes and data.

Syntax:

"'^BMF-<vt addr range>,<button states range>,<data>'"

Variables:

variable text address char array = 1 - 4000.

button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons

1 = Off state and 2 = On state).

level range = 1 - 600 (level value is 1 - 65535).

data:

’%B<border style>’ = Set the border style name. See theBorder Styles by Numbers table on page 38.

’%B’,<border 0-27,40,41> = Set the borer style number. See theBorder Styles by Numbers table on page 38.

’%DO<1-5><1-5><1-5><1-5><1-5> = Set the draw order. Listed from bottom to top. Refer to the ^BDO command on page 52 for more information.

’%F’,<font 1-8,10,11,20-29,32-xx> = Set the font.

’%F<font 01-08,10,11,20-29,32-xx>’ = Set the font.

’%MI<mask image>’ = Set the mask image.

’%T<text >’ = Set the text using ASCII characters (empty is clear).

’%P<bitmap>’ = Set the picture/bitmap filename (empty is clear).

’%I’,<icon 01-9900, 0-clear>’ = Set the icon using values of 01 - 9900 (icon numbers are assigned in the TPDesign4 Resource Manager tab - Slots section).

’%I<icon 01-9900, 0-clear>’ = Set the icon using values of 01 - 9900 (icon numbers are assigned in the TPDesign4 Resource Manager tab - Slots section).

’%J’,<alignment of text 1-9> = As shown the following telephone keypad alignment chart:

’%JT<alignment of text 0-9>’ = As shown the above telephone keypad alignment chart, BUT the 0 (zero) is absolute and followed by ’,<left>,<top>’

’%JB<alignment of bitmap/picture 0-9>’ = As shown the above telephone keypad alignment chart BUT the 0 (zero) is absolute and followed by

’,<left>,<top>’

’%JI<alignment of icon 0-9>’ = As shown the above telephone keypad alignment chart, BUT the 0 (zero) is absolute and followed by ’,<left>,<top>’

Mio Modero R-4

47

 

 

Page 53
Image 53
AMX Mio Modero R-4 manual Button Commands with Embedded Codes, Bmf, BMF-vt addr range,button states range,data