Camera Pods
To configure a camera:
Note: From the Navigation pane, you can
to launch the Pelco Web interface for the camera. This will allow access to additional required configuration settings.
1.For integrated cameras or cameras connected to the appliance,
2.For IP cameras that are shared, for example Pelco cameras,
For more information on shared cameras, see “Pod, Pelco Camera, and Rack Access
3.From the window that appeared, select the camera to configure, then configure the camera by using the buttons described below and in greater detail on the following pages:
–Click Settings to specify labels for the camera, to specify an interactive camera frame rate limit and interactive camera mode limit.
–Click Capture to configure the camera image capture settings.
–Click Masking to configure the camera motion sensor and to specify motion and
–Click Visual Modes to specify the imaging mode and to specify the window to use with Pan and Scan mode. (Not available for Pelco PTZ IP cameras.)
–Click Sensors to configure the sensors associated with the camera and to create thresholds for those sensors.
Settings
Select a camera from the Camera Pods window and click Settings to open the Camera Pods Settings window. From this window you can configure the following camera settings.
Note: Fields displayed may vary depending on the features of the camera selected.
Field | Description |
|
|
Pod Label | The label that identifies the device. This field does not appear for |
| integrated cameras. For integrated cameras the Pod Label is set for |
| the appliance. |
| For more information, see “Settings” on page 69. |
Camera Label | An additional label for the camera. If you provide both a Pod Label |
| and a Camera Label, images and alerts generated by this device are |
| identified as Pod Label (Camera Label). |
Microphone Label | An additional label for the microphone on this pod (camera pods |
| and CCTV adapter pods only). |
NetBotz Appliance User’s Guide | 36 |
