Asante Technologies 9000 manual Installation and Set-up

Installation and Set-up

❑United States—National Fire Protection Association (NFPA 70); United States National Electrical Code

❑Canada—Canadian Electrical Code, Part I, CSA C22.1

❑Other countries—International Electrotechnical Com- mission (IEC) 364, Part 1 through Part 7

▲Important: Take the following precautions when installing the IntraChassis 9000:

Only trained and qualified personnel should be allowed to install or replace this equipment.

This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260 Clause 1.2.14.3 Service Personnel.

Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals.

Unplug the power cord before you work on a system that does not have an on/off switch.

Before installing the IntraChassis 9000, unplug the power cord.

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Do not touch the power supply when the power cord is connected. Line voltages are present within the power sup- ply when the power cord is connected.

Read the installation instructions before you connect the system to its power source.

This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power supply cords before servicing the unit.

Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury and equipment damage.

Page 2-2