Asante Technologies 9000 manual Installation Overview, Rack Mounting/Desktop Placement

Installation Overview

Installation Overview

The table below describes the steps needed to install the IntraChassis 9000. The steps that are optional are labeled “optional” and the steps that are required are labeled “required.” The sections that follow explain each step in detail.

Step	Action to Be Taken
1(Required)	Open the box and check the contents.
	See the Package Contents sheet for a complete list of the items
	included with your IntraChassis 9000.
2(Required)	Install the IntraChassis 9000 chassis in an equipment rack or wall
	rack, or prepare it for desktop placement. See page 2-5.
	Important! When fully loaded, the IntraChassis 9000 can weigh
	over 100 lbs (45 Kg). Use proper lifting equipment and tech-
	niques to prevent back and other injuries.
3(Required)	Install the modules you have purchased for your IntraChassis 9000
	and ensure each is properly seated and locked in place. See page 2-9.
4(Optional)	Install a second power supply module and make sure it is properly
	seated in the chassis. See page 2-11.
5(Required)	Connect the power supply or power supplies.
	See page 2-11.
6(Required)	Connect the modules to your network cables. See page 2-12.
7(Required)	Configure the IntraChassis 9000 for management capabilities.
	See page 2-13.
	Table 2-1 Installation Overview

Rack Mounting/Desktop Placement

The IntraChassis 9000 chassis can be installed in a standard 19-inch equipment rack. It can also be placed on a stable horizontal surface with support capabilities of 150 pounds (68.2 kilograms).

▲Important: The equipment rack or desk on which you install your IntraChassis 9000 must be secure and stable. Equipment racks must be fastened to the floor; desks must be resting on a flat, stable surface.

Page 2-5