Asante Technologies 9000 Performing a Software Upgrade, Basic Configuration Setting Description

Basic Configuration

Setting	Description
Bank 1 Image Version/	The version number and compilation date of runtime code that is
Date	stored in memory Bank 1 on the IntraChassis 9000.
Bank 2 Image Version/	The version number and compilation date of runtime code that is
Date	stored in memory Bank 2 on the IntraChassis 9000.The (Run-
	ning) designation indicates that the runtime code is currently run-
	ning on this Bank. The same as the image file in the boot bank.
Download Protocol	Current setting of the IntraChassis 9000’s serial download proto-
	col.

Current Baud Rate

Transmission rate for the IntraChassis 9000’s serial port.

Destination Bank

Number of the memory bank where the image file will download.

Table 3-9 X/Y/Z Modem Image File Downloading settings

Performing a Software Upgrade

Use the following procedure to upgrade the IntraChassis 9000 software through its serial (console) port.

1 In the Image File Download Configuration menu, type x to open the X/Y/Z Modem Image File Downloading menu.

2 Type x, y, or z to select the corresponding modem protocol.

◆Note: For information about these protocols, see the manual for your communications software.

3 Type c to select the console baud rate. The Baud Rate Set- ting menu appears, as shown in Figure 3-25. The maximum baud rate currently supported is 57,600 bps.

Page 3-42