Installation and Set-up

always check.

Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.

Carefully examine your work area for possible hazards such as moist floors, ungrounded power extension cables, and missing safety grounds.

Never install telephone jacks in wet locations unless the jack is specif- ically designed for wet locations.

Never touch uninsulated telephone wires or terminals unless the tele- phone line has been disconnected at the network interface.

Never touch uninsulated telephone wires or terminals unless the tele- phone line has been disconnected at the network interface.

Power Requirements

The source electrical outlet should be installed near the IntraChassis 9000 and easily accessible. It must also be properly grounded.

Make sure the power source adheres to the following guidelines:

Voltage range: 100 to 240 VAC

Frequency range: 60/50 Hz

Maximum current: 10 A per power supply at 110 volts

Environmental Requirements

The IntraChassis 9000 must be installed in a clean, dry, dust-free area with adequate air circulation to maintain the following environmental limits:

Temperature: 0° to 40° C (32° to 104° F)104°

Relative Humidity: 5% to 85% non-condensing

Avoid direct sunlight, heat sources, or areas with high levels of electromagnetic interference.

Cooling and Airflow

Do not restrict air flow by covering or obstructing air vents on the sides of the chassis.

Page 2-4

Page 24
Image 24
Asante Technologies 9000 manual Power Requirements, Environmental Requirements, Cooling and Airflow