2.Set the Options DIP switches by following these guidelines:

Switch 1 sets all system transmitters in the interior zone to either of the following

ON = interior delayed

OFF = interior instant

Switch 2 determines whether the Central Controller’s internal sounder is on or off during an intrusion alarm.

ON = silent

OFF = on

Switch 3 sets the Central Controller'shardwired sensor loop to either of the following:

ON = open loop

OFF = closed loop

Switch 4 sets the Central Controller’s hardwired loop zone to either of the following:

ON = interior

OFF = perimeter instant

B. Mount the Central Controller Use # 8 screws. PLEASE USE A SMALL LEVEL TO MAKE SURE THE HOUSING IS LEVEL BEFORE YOU TIGHTEN THE SCREWS.

Good!Before you begin wiring in all the components, please take a look at the diagram of the Central Controller Terminal Strip on the next page. Each terminal screw is labeled for your information.

AT&T Proprietary Information 2-21

Page 22
Image 22
AT&T 8000 installation instructions AT&T Proprietary Information