AT&T 8000 Program the Transmitters, Let’s look at the I.D. Code for a moment, ID Code

STEP 17

Program the Transmitters

An easy way to program the transmitters is to begin by setting the I.D. code for each one while you have them all together (in the kitchen of wherever you’re working). That way, since you can look at them ail at once, you’ll be sure not to give the same I.D. number to more than one transmitter.

Let’s look at the I.D. Code for a moment.

Identification Codes	Each transmitter in the system must have a unique code number.
	Fivee DIP switches are used to program the transmitter I.D. The
	I.D. number is used by the Central Controller to relay trouble
	beeps and alarms to specific transmitters. Code numbers 00
	through 31 may be used. Codes 00 through 23 are shown below.
	The Supervised Smoke Detector Transmitter differs from the other
	transmitters in that it only has three I.D. DIP switchess and only
	uses code numbers 24 through 31. These codes are shown on Page
	62.
	Transmitter ID		Switch Settings
	ID Code	1	2	3	4	5
	00	ON	ON	ON	ON	ON
	01	OFF	ON	ON	ON	ON
	02	ON	OFF	ON	ON	ON
	03	OFF	OFF	ON	ON	ON
	04	ON	ON	OFF	ON	ON
	05	OFF	ON	OFF	ON	ON
	06	ON	OFF	OFF	ON	ON
	07	OFF	OFF	OFF	ON	ON
	08	ON	ON	ON	OFF	ON
	09	OFF	ON	ON	OFF	ON
	10	ON	OFF	ON	OFF	ON
	11	OFF	OFF	ON	OFF	ON
	12	ON	ON	OFF	OFF	ON
	13	OFF	ON	OFF	OFF	ON
	14	ON	OFF	OFF	OFF	ON
	15	OFF	OFF	OFF	OFF	ON
	16	ON	ON	ON	ON	OFF
	17	OFF	ON	ON	ON	OFF
	18	ON	OFF	ON	ON	OFF
	19	OFF	OFF	ON	ON	OFF
	20	ON	ON	OFF	ON	OFF
	21	OFF	ON	OFF	ON	OFF
	22	ON	OFF	OFF	ON	OFF
	23	OFF	OFF	OFF	ON	OFF
	24	ON	ON	ON	OFF	OFF
	25	OFF	ON	ON	OFF	OFF
	26	ON	OFF	ON	OFF	OFF
	27	OFF	OFF	ON	OFF	OFF
	28	ON	ON	OFF	OFF	OFF
	29	OFF	ON	OFF	OFF	OFF
	30	ON	OFF	OFF	OFF	OFF
	31	OFF	OFF	OFF	OFF	OFF

AT&T Proprietary Information

2-42