
b. Plug each security code post into the slot for the number desired.
Blue Wiie | = | First Number |
White Wire | = | Second Number |
Yellow Wire | = | Third Number |
NOTE: The proper wire sequence is easy to remember since the alphabetical order of the colors is the same as the order of the numbers they represent:
1st = B | 2nd = W | 3rd = Y |
3.Check the voltage on the 9 volt battery using your meter. It should register 9 volts. Then connect the 9 volt battery.
Check the current draw.
4.Log the transmitter location on the Central Controller Zone Locator Card.
5.Temporarily place the transmitter in the area that it will be mounted. Use
6.Enter the Installer Test Mode, as described below.
a.Enter the transmitter security code and then press the Off key to put the system in the Off state.
NOTE: Next, quickly press the Test/Demo key (Step b.). If it is held down for more than 3 seconds, the Demonstration Mode will be entered, instead of the Installer Test Mode and a
To clear this condition: Press the Test/Demo key once to exit the Demo Mode.