STEP 13

1.

Install Sensors that Utilize the Central

2.

Controller hardwired Loop and

Auxiliary Power

3.

4.

5.

6.

Select sensor location.

Remove all power to Central Controller before installing

sensor.

Connect hardwired loop sensor wire to the Central Controller.

. Use screw terminals 5 and 6.

Connect auxiliary power wire to the Central Controller.

. Use screw terminals 11 (+) and 12 (-).

Reconnect power to Central Controller.

Test the sensor to see if it causes an alarm.

If not, check voltage on 11 and 12.

AT&T Proprietary Information

2 - 3 7

Page 38
Image 38
AT&T 8000 installation instructions Sensor