Deleting Records
Deleting Records
There are two ways to delete entire records:
1.Navigate to the record in “view” mode and then push and hold 
and push 
.
2.Navigate to the record in “view” mode, then push 
to change to “edit” mode, then delete all the characters on all three lines (see “Editing Records” section above for information about ways to delete single characters, multiple characters, and
entire lines). After deleting all three lines of characters and with the cursor on line 3,
push 
or 
.
No matter which of these two ways you use, Logio will prompt as follows:
Push 
to delete the record, or push 
to cancel deleting. After you delete a record, you will then be back in “view” mode and the screen will display the record that follows the one you deleted, unless there is no following record, in which case the screen will display the first record that precedes the one you deleted. If you cancelled the deletion, the screen will display the record you decided not to delete.
Logio User’s Manual, page 23
