ATTO Technology SC 5700 operation manual FastStream SC 5500 Physical Attributes, SAS/SATA ports

1.2 FastStream SC 5500 Physical Attributes

The ATTO FastStream SC 5500 is a Fibre Channel to SAS/SATA SAN storage appliance which can be seamlessly integrated into a new or an existing storage environment.

The ATTO FastStream SC 5500 is available in a desktop model, an industry-standard 1U form factor for easy integration into racks and as an embeddable board-level product.

For installation instructions for the desktop and 1U form factor models, refer to Install the FastStream Storage Controller on page 9.

For installation instructions and physical attribute details for the embeddable model, refer to the ATTO Embedded Storage Controller Installation and Operation manual.

Dimensions

Width: 17.31 inches

Length: 9.9 inches

Height: 1.69 inches (1U)

Weight: approximately 8 pounds

Cooling and airflow

Operating Temperature: 5 °C-40 °C

Humidity: 10-90% non-condensing

CAUTION

Do not block the enclosure’s vents. The FastStream does not allow data transfer if overheating occurs. Ambient air should not exceed 40 °C.

Explosionsgefahr, wenn die Batterie falsch entfernt und/oder ersetzt wird. Entsorgen Sie benutzte Batterien in Übereinstimmung mit Ihren lokalen Umweltschutzbestimmungen.

Fibre Channel ports

The two independent 4-Gigabit Fibre Channel ports connect the FastStream SC 7500 to Fibre Channel hosts using optical SFP connectors and multimode fiber optic cable.

Make sure all cables are anchored securely at both ends with the proper connectors.

SAS/SATA ports

The two (x4) 3-Gb SAS/SATA ports connect storage devices into the Storage Area Network (SAN) using mini SAS 4x cable plug connectors.

Management ports

Management is provided using the 10/100/1000 base T Ethernet port accessible from the RJ-45 connector or the RS-232 serial port using an RJ-11 connector.

(See Exhibit 1.2-1).

Power

Input voltage: 100-240 VAC, 2.5A, 47-63 Hz

Battery-backed event log: A rechargeable Lithium ion battery cell holds the event log memory for up to 30 days. If the FastStream has been disconnected from power, recharging begins automatically when power is restored to the system. The battery is fully charged after 36 hours of continuous power application.

WARNING WARNING

Risk of explosion if battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.

Reset/restore factory default switch

To reset the FastStream, briefly insert a tool in the hole in the back panel for less than three seconds. See Exhibit 1.2-1.

To restore factory defaults, insert the tool in the hole in the back panel for more than four seconds until the green Ready LED blinks.

LED indicators

The LED indicators can be viewed from the connector side and the front side of the FastStream. (See Exhibit 1.2-2 and Exhibit 1.2-3)

LEDs on the connector side are: Ready/Fault LED lights green to indicate ready, lights yellow to show a faulted condition, and is off to indicate not ready.

5

ATTO Technology Inc. FastStream SC Installation and Operation Manual