ATTO Technology SC 5700 operation manual FastStream SC 5300 Physical Attributes

1.1 FastStream SC 5300 Physical Attributes

The ATTO FastStream SC 5300 is a Fibre Channel to SCSI storage appliance which can be seamlessly integrated into a new or an existing storage environment.

The ATTO FastStream SC 5300 is available in a desktop model and in an industry-standard 1U form factor for easy integration into racks.

For installation instructions, refer to Install the FastStream Storage Controller on page 9.

Dimensions

Width: 17 inches

Length: 8.94 inches

Height: 1.7 inches (1U)

Weight: approximately 8 pounds

Cooling and airflow

Operating Temperature: 0°-40° C external

Humidity: 10-90% non-condensing

Airflow: air enters through slots on the right of the rear panel and exits through slots on the left of the rear panel.

CAUTION

Do not block the enclosure’s vents. The FastStream does not allow data transfer if

automatic with no manual or jumper switchover required.

Power draw: 2 amps at 110V, 1.6 amps @ 90V

Fibre Channel ports

Two independent 4-Gigabit Fibre Channel ports connect the FastStream using Small Formfactor Pluggable (SFP) interfaces and multimode fiber optic cable.

SCSI ports

The two SCSI ports are totally independent from each other.

The ports are Ultra 320 SCSI busses with VHDCI connector, downward compatible with all forms of Single-ended Differential SCSI and all previous SCSI protocols.For details on cabling SCSI ports, refer to SCSI Cabling on page xxiii of the Appendix.

Management ports

The 10/100 base T Ethernet port is accessible from the RJ45 connector and supports local diagnostics.

overheating occurs.

Power

The power supply circuit is permanently mounted within the enclosure and is not hot-swappable. It has one standard IEC320 power receptacle and switch.

The RS-232 serial port provides support for remote monitoring and management using a DB9 connector. The baud rate is programmable and preset at the factory to 115200 bps.

1	6
RX 2
	7
TX 3
	8
4
	9
GND 5

WARNING

Risk of explosion if battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.

Explosionsgefahr, wenn die Batterie falsch entfernt und/oder ersetzt wird. Entsorgen Sie benutzte Batterien in Übereinstimmung mit Ihren lokalen Umweltschutzbestimmungen.

Input voltage: 10/230V AC, with operating input range of 90-132V AC or 175-264V AC, 47-63Hz, single phase. The AC input range selection is

LED indicators

The LED indicators can be viewed from the connector side and the front side of the FastStream SC 5300. (See Exhibit 1.1-1, Exhibit 1.1-2 and Exhibit 1.1-3.)

LEDs on the connector side are:

A bicolor Ready/Fault LED lights green to indicate ready, lights yellow to show a faulted condition, and is off to indicate not ready.

Embedded in the Ethernet port connector: a lighted green LED shows a valid link; off indicates that no link is present. A separate blinking yellow LED indicates activity.

Fibre Channel ports: A lighted green LED indicates link; off means no link. A separate green LED indicates activity if it is lit, no activity if it is off.

3

ATTO Technology Inc. FastStream SC Installation and Operation Manual