RMStatus
Displays the status of all RAID members within the specified RAID group or a particular RAID member if specified within the specified RAID group.
RMStatus [GroupName] <MemberIndex>
Route
SC 5300
Assigns a host protocol address to a target destination device. More than one FC LUN may be assigned to a partition. If you try to map a new partition to the same FC LUN, the previous map is overwritten. Use the delete identifier to remove the map. In verbose mode, overwriting a map requires secondary confirmation of the action.
If FCMultiNode is disabled: Route FC [lun] [RAID [GroupName] [PartIndex]] Delete]
If FCMultiNode is enabled: Route FC [fp] [lun] [RAID [GroupName] [PartIndex]] Bridge Delete]
Route
SC 5500
Assigns a host protocol address to a target destination device. More than one FC LUN may be assigned to a partition. If you try to map a new partition to the same FC LUN, the previous map is overwritten. Use the delete identifier to remove the map. In verbose mode, overwriting a map requires secondary confirmation of the action.
You may also map pass through devices.
If FCMultiNode is disabled: Route FC [lun] [RAID [GroupName] [PartIndex]] SAS [SASIndex] ] Delete]
If FCMultiNode is enabled: Route FC [fl] [lun] [RAID [GroupName] [PartIndex]] SAS [SASIndex] ] Delete]
Route
SC 5700
Assigns a host protocol address to a target destination device. More than one FC LUN may be assigned to a partition. If you try to map a new partition to the same FC LUN, the previous map is overwritten. Use the delete identifier to remove the map. In verbose mode, overwriting a map requires secondary confirmation of the action.
You may also map pass through devices.
If FCMultiNode is disabled: Route FC [fl] [RAID [GroupName] [PartIndex]] FC [fp] [Index]] Delete]
If FCMultiNode is enabled: Route FC [fp] [fl] [[RAID [GroupName] [PartIndex]] FC [fp] [Index]] Delete]
RouteDisplay
Displays a combined list of host protocol address to target destination device mappings.
If FCMultiNode is disabled: RouteDisplay [FC] <lun> passthrough persistent>
If FCMultiNode is enabled: RouteDisplay [FC] <<fp> <lun>> passthrough persistent>
SASTargets
SC 5500
Lists the physical devices that are connected to all SAS ports.
SASTargets
SaveConfiguration
Issued with the restart option, cycles unit power after saving configuration changes. The norestart option saves changes without restarting.
Note
Certain modifications require a system restart.
SaveConfiguration <Restart NoRestart>
SCSIDomainValidation
SC 5300
Runs Domain Validation tests on the SCSI system which may detect problems with SCSI cables, termination or damaged transceivers. Tape drives attached to the FastStream should be loaded with media. The media is not overwritten.
SCSIDomainValidation
SCSIInitID
SC 5300
Specifies the persistent SCSI initiator ID used by the unit on this SCSI bus. All maps coinciding with the
Default: 07
set SCSIInitID [sb]
SCSIPortBusSpeed
SC 5300
Controls the transfer rate at which the unit attempts to negotiate with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast ultra ultra2 ultra160 ultra320]
get SCSIPortBusSpeed [sb]
xv
ATTO Technology Inc. FastStream SC Installation and Operation Manual
