ATTO Technology SC 5700 BlockDevClean, BlockDevIdentify, BlockDevIDStop, BlockDevScan, Boot Delay

BlockDevClean

Removes any RAID configuration data from the block device with the specified block ID.

CAUTION

All RAID group setup information is lost and you lose all RAID group data.

BlockDevClean [BlockDevID]

BlockDevIdentify

Lights the LED of a disk drive. Use either RAID GroupName and MemberIndex, or block ID.

BlockDevIdentify <GroupName> [BlockDevID MemberIndex]

BlockDevIDStop

Turns off the IO LED of a previously identified disk drive.

BlockDevIDStop

BlockDevScan

Lists all currently-connected physical block devices and any potential RAID group association. Each block device listed is assigned a unique index at the time of the scan which is used to identify block devices for other CLI operations.

FastStream SC 5300 only: If you wish to force rediscovery of all block devices, use the flush parameter. If you uses it, all existing RAID groups are forced offline until member block devices are discovered.

BlockDevScan <flush>

Boot Delay

Regulates the delay (in seconds) which the unit waits after startup before allowing hosts to detect target devices. The value 0 produces no delay.

Default: 5

set BootDelay [0-255] get BootDelay

BridgeModel

Reports specific model and firmware information.

get BridgeModel

BridgeName

Specifies an ASCII name assigned to the unit to identify individual units. It is not the World Wide Name. Changes take effect immediately. The name may be contain up to 8 characters.

set BridgeName [name]

SaveConfiguration Restart command required get BridgeName

vii

ClearEventLog

Clears the contents of the EventLog. No new entries are recorded until the operation is completed.

ClearEventLog

Date

Regulates the current date for this unit. The date range is 1/1/2000 to 12/31/2099.

set Date [MM] / [DD] / [YYYY] get Date

DefaultInterleave

Assigns or retrieves the system’s default interleave size (in 512- byte blocks) for new RAID groups (before RGCommit has been used). If an interleave size is not explicitly specified when a RAID group is created, then the DefaultInterleave value is used instead.

Default: 128

set DefaultInterleave [16 32 64 128 256 512 1024 2048]

SaveConfiguration Restart command required get DefaultInterleave

DeleteAllMaps

Removes all mapped devices from the map table. Upon the subsequent POST, the default maps are loaded if no maps are present.

DeleteAllMaps

SaveConfiguration command required

DisplayEventLog

Displays the EventLog.The event log may be filtered using the DisplayEventLogFilter command. The optional parameter n is the number of lines to be displayed as a single page with no user interaction. After the command has executed, use +, - or = to scroll through the log. Type quit and press Enter to exit the command.

DisplayEventLog <n>

DisplayEventLogFilter

Filters the display of data for specified subsystems and levels during DisplayEventLog mode. Valid event log subsystem entries are platform-dependent. For set commands, the final parameter indicates whether or not events from the specified subsystem and level are displayed.

Default: all all all

set DisplayEventLogFilter [subsystem all] [level all] [all none]

get DisplayEventLogFilter [subsystem all] [level all]

ATTO Technology Inc. FastStream SC Installation and Operation Manual