FCPortList

Displays a list of available FC ports and their current status. Valid reported status values are Up, Down, Failed, Reserved and Disabled.

FCPortList

FCSCSIBusyStatus

SC 5300

Choose to report busy or queue full when the unit is unable to accept a SCSI command.

Default: busy

set FCSCSIBusyStatus [busy qfull] get FCSCSIBusyStatus

FCTargets

SC 5700

Lists all target devices available on the Fibre Channel port with the index specified by fp. If no port index is specified, then all target devices on all Fibre ports are displayed. A port-unique index is assigned to each target which is used with the fp to specify a Fibre Channel target for a subsequent Route CLI command.

FCTargets <fp>

FCWWName

Reports the World Wide Port Name of the Fibre Channel interface referenced. Each Fibre Channel port has an individual and unique 8-byte Port Name.

get FCWWName [fp all]]

FirmwareRestart

Resets and reinitializes the unit firmware. Use the forced option to override any CLI reservations held by other sessions.

FirmwareRestart <forced>

Help

Issued with no parameters displays a list of available CLI commands. When a CLI command name is specified, a command usage string and command description are displayed.

Help <Command>

HSAdd

Assigns a Block Device to the Hot Spare pool.

HSAdd [BlockDevID]

HSDisplay

Displays a list of all of the devices in the Hot Spare pool.

HSDisplay

HSRemove

Removes a Block Device from the Hot Spare pool.

HSRemove [BlockDevID] [all]

IdentifyBridge

If you enable this command, the Fault LED on this unit blinks so that hardware may be identified. Disabling this option cancels the blinking..

Default: disabled

set IdentifyBridge [enabled disabled] get IdentifyBridge

Info

Displays version numbers and other product information for key components within the unit.

Info

IPAddress

Controls the current IP address of the Ethernet port(s) on the unit. If IPDHCP is enabled, the get command reports the current IP address assigned by the network DHCP server, followed by the (DHCP) identifier.

Default: 10.0.0.1

set IPAddress [mp1] [xxx.xxx.xxx.xxx] SaveConfiguration Restart command required get IPAddress [mp1]

IPDHCP

Regulates how the unit acquires its IP address. When disabled, the unit uses the IP address specified by the IPAddress CLI command; when enabled, the unit gets its IP address from a DHCP server.

Default: enabled

set IPDHCP mp1 [enabled disabled] SaveConfiguration Restart command required get IPDHCP

IPDNSServer

Controls the current DNS Server address. If IPDHCP is enabled, the DNS Server address is automatically detected. If IPDHCP is disabled, you must set the address manually using this command.

set IPDNSServer mp1 [xxx.xxx.xxx.xxx] get IPDNSServer

IPGateway

Controls the current default gateways used by any Ethernet port(s) on the unit. If IPDHCP is enabled, the get command reports the current IP gateway assigned by the network DHCP server.

Default: 0.0.0.0

set IPGateway [mp1] [xxx.xxx.xxx.xxx] SaveConfiguration Restart command required get IPGateway [mp1]

x

Page 57
Image 57
ATTO Technology SC 5700 FCPortList, FCSCSIBusyStatus, FCTargets, FCWWName, FirmwareRestart, Help, HSAdd, HSDisplay, Info