Avaya 518-456-804 manual Adding New Modules

Quick Reference Guide 6 Maintaining Your System

Adding New Modules

Adding new modules to an existing 5-slot carrier is very similar to installing the control unit.

Use these instructions if you are adding modules to an existing 5-slot carrier. If you are upgrading from a stand-alone PARTNER ACS processor module to a 2-slot carrier, see “Wall-Mounting a Stand-Alone Processor Module and a 2-Slot Carrier” on page 14 for instructions.

CAUTION:

Before starting, verify that you have batteries installed in the processor module by viewing the display of the telephone at extension 10.

Follow these steps to add a module to an existing 5-slot carrier:

1Move the On/Off switch to the “Off” position (“O”).

2Remove the power cord from the wall outlet.

3Perform the following steps to remove the cover:

aLoosen the thumb screw at the bottom of the carrier cover.

bRotate the carrier cover to disengage the tabs at the top of the modules from the openings on the top of the carrier cover.

4Before installing a module, remove the clear, plastic protector from the connector area on the rear of the module by grasping the tabs on the ends of the protector and lifting.

Adding New Modules 75