Quick Reference Guide | 6 Maintaining Your System | |
|
|
|
5Power up the system:
aReconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic case. Do not install the power cord at an angle to the case or with a loop in it.
bIf you have a
The LEDs on the processor module (center slot) will alternate red/green while the upgrade is being performed. When the upgrade is finished, the LED will appear steady green.
6Make sure each module has a green LED in the same horizontal area, and that they all appear steady green. This indicates that each module is powered up.
•PARTNER ACS Release 7.0 provides a firmware upgrade capability for the 1600 DSL module. If you are performing a firmware upgrade of this module, see “Upgrading 1600 DSL and 012E Module Firmware” on page 73 for a description of how the LEDs appear during the upgrade.
•PARTNER ACS Release 7.0 provides a firmware upgrade capability for the 012E module. If you are performing a firmware upgrade of this module, see “Upgrading 1600 DSL and 012E Module Firmware” on page 73 for a description of how the LEDs appear during the upgrade.
•If a single light is out, power down the control unit, reseat the module and power up the control unit.
•If multiple lights are out, power down the control unit, reseat the leftmost module that has a light out, and power up the control unit.
•If the lights are still out, call for support as instructed on the inside front cover of this guide.
Using a PC Card 71
