Banner L-GAGE manual GAGELT3 Specifications cont’d, 247

			MEASUREMENT & INSPECTION
	L-GAGE®LT3 Specifications (cont’d)
Laser Control	Connect red wire to +5 to 24V dc to enable laser beam; connect to 0 to +1.8V dc
	(or open connection) to disable; when sensor is powered laser enable time is 100 millisecond delay on
	enable, when sensor is powered.
Indicators	Green Power ON LED: Indicates when power is ON, overloaded output and laser status
	Yellow Output LED: Indicates when discrete load output is conducting
	Red Signal LED: Indicates target is within sensing range and the condition of the received light signal
	Yellow Speed LED: Indicates the response speed setting
	Red/Yellow TEACH LEDs: In programming mode; indicate active output(s)
Construction	Housing: ABS/polycarbonate blend
	Window: Acrylic
	Quick-disconnect:ABS/polycarbonate blend
Environmental Rating	IP67; NEMA 6
Connections	2 m or 9 m shielded 7-conductor (with drain) PVC-jacketed attached cable, or 8-pin Euro-style
	quick-disconnect. QD cables are ordered separately. See page 416.
Operating Conditions	Temperature: 0° to +50° C Relative humidity: 90% at 50° C (non-condensing)
Application Notes	• For best accuracy, allow 30-minute warm-up before programming or operating
	• Retroreflective performance specifications are based on use with supplied BRT-TVHG-8X10P
	high-grade target. Results may vary with other retroreflective target materials.
Certifications
	R
Hookup Diagrams	Discrete/Analog Models:	NPN: MI01 (p. 532)	PNP: MI02 (p. 532)
	Dual-Discrete Models:	NPN: MI03 (p. 532)	PNP: MI04 (p. 532)

LIGHT ULTRASONIC MEASURING TEMPERATURE RADAR

GAUGINGLIGHT SCREENS

More information online at bannerengineering.com 247