Barco DX-700 ~ ~

DX-700 • User’s Guide • Rev 02 53

2. Hardware Orientation

DX-700 Rear Panel

6) DVI Monitor Out

One DVI-I connector is provided for the DVI Monitor Output. In Appendix A,

refer to the “DVI-I Connector Pinouts” section on page180 for DVI-I connector

pinouts. Refer to the “DX-700 Monitor Outputs” section on page54 for addit ional

information on both monitor output ports.

7) DMX In

One XLR5 connector is provided for DMX Input. This port enables you to control

the DX-700 from a lighting console or other DMX-capable device. In Appendix A,

refer to the “DMX Connector” section on page18 4 for pinouts.

8) DMX Thru

One XLR5 connector is provided for DMX Thru. This port enables you to loop

control from the “master” DX-700 to additional slave units. In Appendix A, refer to

the “DMX Connector” section on page 184 for pinouts.

9) Ethernet

One RJ-45 connector is provided for 100BaseT Ethernet communications with

DX-700, using a socket connection over TCP/IP. The port is typically used for

communications with Barco’s Director Toolset Graphical User Interface (GUI).

The DX-700 defaults to DHCP operation. The default static IP address is

192.168.000.200. Please note:

~The DX-700 returns to the DHCP mode after a factory reset.

~This address can be changed using the Ethernet Menu. In Chapter4,

refer to the “Using the Ethernet Menu” section on page142 for details.

In AppendixA, refer to the “Ethernet Connector” section on page 183 for

pinouts.

10) Diagnostic Port

One 9-pin D connector (Diagnostic) is provided for RS-232 serial

communications with the DX-700. The port is reserved for factory and technical

support use only.

In AppendixA, refer to the “Diagnostic Connector” section on page 183 for a

connector illustration.

Note DMX control is currently not implemented.

Note DMX control is currently not implemented.

Contents

Main auJTMM==r=d ` k c~=`~=`=Ec``F=p~ d~~=~=`~ `~=^ l~=p~=p~ q=f=q=j~~=~=b=j~= `~=e q~==` `~=O e~~=l~=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=PP Page Page `~=R r~=c~=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KNST ^=_= o=`=mK=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KNUR ^=`= `~=f~=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KOMP ^=a= c=kkf=f~~K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=K=KOMR Page NK==f c~=s `~=p e==r=q=d k~~ q~==`=~=f `= ^==auJTMM l _~=c~ k=c~ c~=s=OKNM=c~ c~=s=OKPM=c~ q==l~ f===`~~ f===t~ p~=asf=l=j=`~ Note Important Figure 1-2. Sample DVI canvases that use one output module 2 1 Note and aspect ratio, and that the outputs can be used individually or grouped to form larger walls. p~=kkf=l=j=`~ r~=_~ p=_~=`~ ~ j=_~=`~ Important Note d=l auJTMM=p~ Note b~=p~ auJTMM=p~ ~ ~ auJTMM=s=m=a~ ~ ~ ~ ~ ~ ~ ~ auJTMM=f=f~ auJTMM=f=p ~ ~ c~=r~ `=a~~ This section provides several sample single bank connectivity diagrams. p=_~I=p=f=pI=p=l Connectivity Diagrams p=_~I=q=f=pI=r=l Figure 1-8. Sample system configuration: triple input, triple output (ungrouped) p=_~I=p=f=pI=d=l OK==e~~=l~ auJTMM=c=m~ 31 52 1 64 ~ Important q=p q=p=` a cb d ~ q=m~ Note Page auJTMM=o~=m~ ~ 1 2 3 f=j f=j=_=a~~ f=j=a Page DX-700 Users Guide Rev 02 43 DX-700 Rear Panel Output Blank ~ Figure 2-4. Sample Expansion Port configuration, external stacking ~ Figure 2-5. Sample Expansion Port configuration, cross-bank stacking Master Slave Output System ~ l=j l=j=a DX-700 Rear Panel l=j=_=a~~ The figure below illustrates a simplified block diagram of the DVI Output Module: The figure below illustrates a simplified block diagram of the NNI Output Module: DVI Output Module NNI Output Module asf=l=j Page kkf=l=j Page p=j Page ~ ~ auJTMM=j=l DX-700 Users Guide Rev 02 55 Module Installation and Configuration Bank 1 Bank 1 Correct Justification Incorrect Justification j=f~~=~=`~ j=`~=o one input module and one output module to route video to an LED wall. Output Section must always be an Output Module, and it must always be right- j=f=~=b~ j=f Caution j=b~ p=p~=j Caution Page PK==f~~ p~=m~= r~=~=f= p=m~~= `~=~=^~=f~ o~Jj=f~~ m=f~~ m=`Li=s~=p Warning Avertissement Warnung p~=` Note Note Note Important Warning Warning Note 68 DX-700 Users Guide Rev 02 Format Connection Table c~=`=q~ Cells with checks denote the connections required for the indicated format. QK==l~ n=p=~=l~ Important n=c=o Page Page Page `==auJTMM ~ Note mJr=f~~ Important r==e=j l=q~=a r==p=t~ DX-700 Users Guide Rev 02 81 Using the Setup Wizard Figure 4-5. Setup Wizard Menu Tree for DVI Output Modules p=t~=j=q Output Modules: 82 DX-700 Users Guide Rev 02 Figure 4-6. Setup Wizard Menu Tree for NNI Output Modules buttons have been omitted for simplicity. Note p=t~=l~ Important Page ~ ~ ~ Note ~ ~ Page ~ Important ~ Important ~ Note Important ~ d=`=p Caution Note DX-700 Users Guide Rev 02 93 Using the Input Wizard r==f=t~ f=t~=j=q The figure below illustrates the Input Wizard menu tree: f=t~=l~ ~ ~ ~ ~ ~ Note Page ~ S ~ Note ~ S ~ ~ ~ ~ ~ S Note Important Note ~ Important Tip ~ r==m=j~~=j m=j~~=j=q m=j~~=l~ o~=~=m ~ o~=~=m Tip a=~=m a=^=m DX-700 Users Guide Rev 02 107 Using the Input Management Menu Figure 4-41. Input Management Menu Tree r==f=j~~=j f=j~~=j=q The figure below illustrates the Input Management menu tree: f=j~~=l~=l f=j~~=j=l~ d~=f=j~~=c `~=wJl Power Blank Output System Page ^=t=p ~ ~ ~ ~ ~ ~ Page ^=s=p ~ ~ ~ ~ ^=f~=m=m~~ ~ ~ ~ ~ ~ Note Page ^=f=_~~ ^=s=b ^=`=b ^=f=q Page p~=f=j~~=p Note ~ ~ Note Page DX-700 Users Guide Rev 02 125 Using the Display Management Menu Figure 4-59. Display Management Menu Tree a~=j~~=j=q The figure below illustrates the Display Management menu tree: a~=j~~=l~ j~~=iba ~ Page Page j~~=c=p Note Page Page c==a~ ~ ~ Note r==auJTMM=j~~=j DX-700 Users Guide Rev 02 135 DX-700 Management Menu Tree Figure 4-71. DX-700 Management Menu Tree auJTMM=j~~=j=q The following figure illustrates the DX-700 Management menu tree: auJTMM=j~~=j=l~ ~ Note r==auJTMM=p~=j ~ s=q=m~=p~ s=q=m=p~ ~ ~ ~ k~==auJTMM=r ~ ~ r==b=j r==a~=j Page r==c=m~=a~=^=j o==p o==p ~ m=~=c~=o ~ Note r==q=m~=j Note Tip r==j=l=j Note ~ r==bafa=j Page r~=d=l p=d=r==_~=p=j Important Page Page ~ p==j~=p=p ~ ~ r==b=j Note mJ===a~=j ~ o==`~~=p ~ ~ Important p=l=q Page Note p~=auJTMM=j~~=p ~ Note c=m~=i ~ ~ ~ ~ Tip Page RK==r~=c~ 5. Upgrading Firmware c~=r~=l e~~=o `=~=a~=o r~=c~ 5. Upgrading Firmware S Note Page ^K==p~ Input Specifications f=p~= The table below lists DX-700 input specifications. Input Specifications l=p~ asf=l=j kkf=l=j d=p~ Physical and Electrical Specifications m~=~=b~=p~= The table below lists DX-700 physical and electrical specifications. `~=p~= ^=p~= a~=p~ a~=q~=RM=e a~=q~=SM=e Pinouts m= ^~=NRJ=a=` The figure below illustrates the analog 15-pin D connector: The table below lists Analog 15-pin D connector pinouts. asfJf=`=m p~~=asfJf=` m~=asfJf=` b=` a~=` aju=` kkf=` Note Warning _K==o=`=m o=`~ `~=p l r~Lp=`~=c~ n=`~=c~ auJTMM=o==`~ ~ ~ ~ ~ S f~=k b~=`~ DX-700 Remote Command Table auJTMM=o=`~=q~ The table below lists DX-700 remote commands. Command Description Page auJTMM=o=`~=i l=iba=`~ p`omto t^ii`lkqo t^iid^jj^ t^iilpa t^iilpaifpq\ l=c=`~ cf_booumto cf_bohbvobc cf_bocfiqbo cf_bopk cf_bom`_ cf_boplcq cf_bocfoj cf_booqfjb j=l=`~ jlobp jp^sb jl_^kh m=`~ mp`^ii mpkrj mpmok mqo^kp j~=`~ afp`lsbov tel^obvlr `ilpb _^kh Page `K==`~=f~ t~~ `=p=m~ `K==`~=f~ o=j~~=^~=Eoj^F `~=f~ aK==c=kkf=f~~= l Important Note Caution ~ Note c=kkf=e~~ 65432 c=kkf=q~ 7 Important c=kkf=o 5 643 7 Important iba=b=` Important ~ ~ f~~ r~=~=f= p=m~~= `~=~=^~=f~ p==a=`~===c=l=`~ f~==c=kkf=j ~ ~ p~=` Warning m=e~ m=c=l=`~=j~~= i~=p~ Caution q~=p~ f p k ^ _ ` a b c d e f h i j k l m n o p q r s t v w