DX-700 • User’s Guide • Rev 02 57
2. Hardware Orientation
Module Installation and Configuration
jçÇìäÉ=fåëÉêíáçå=~åÇ=bñíê~Åíáçå
The following procedures apply to input, output, and system modules.

jçÇìäÉ=fåëÉêíáçå

To insert a module:
1. Ensure that the DX-700 power is off.
2. Orient the module so that the power connector is at the bottom.
Figure 2-15. Rear view of module: correct orientation of power connector
3. Carefully insert the module, and push it into the chassis until the module’s top
latch is stopped against the chassis.
Figure 2-16. Module latch stopped against chassis
Power
Connector
Chassis
Module
Latch
Insert module
until the latch
stops against
the chassis