82 DX-700 • User’s Guide • Rev 02
4. Operation
Using the Setup Wizard
The figure below illustrates the Setup Wizard menu tree for NNI Output Modules:
Figure 4-6. Setup Wizard Menu Tree for NNI Output Modules
Note: NNI output module selected
Home Menu
Setup Wizard
Setup Wizard Initial Menu
Next
Bank Selection Menu
Select Output
Display Layout Menu
Display #
Display Reset
H Output Position
V Output Position
Accept Position
Previous
Next
Test Pattern Check Menu
Grid SizeNo
Yes
Output Setup Complete
Next
Yes No
Return?
Click physical
button in Output
Selection Pane
Panel
Display Output Selection Menu
Click physical
output connector in
rear panel view
Input Wizard
Output Frame Rate Menu
Next PAL
NTSC
Computer
Output Selection Menu
Select Bank
Yes No
Not all outputs set
up. Continue?
Test Pattern Check Menu
Grid Size
Yes No
Moving Smoothly?
Yes No
Select this output as
the reduced/minimum
delay output?
Delay mode
disabled
OK
Standard mode
pre-selected Reduced or Minimum
mode pre-selected
Set up additional displays
Dis-similar Tiles Similar Tiles
If two or three
outputs are set up
Select one of the outputs
as the reduced/minimum
delay output?
Yes No
Delay Output Selection Menu
DisplayNext
If one output
is set up If two outputs
are set up
Display
If all outputs
are set up
Delay Mode Dependency
If one output
is set up
If one output
is set up If two or three
outputs are set up
Select Output
Setup Dependency
Setup Dependency
Setup Dependency
Yes No
Rolling Smoothly?
Output Position Menu
H Size
V Size
Next
Detect
Check Cabling
Note In the previous two menu trees, the {Previous} and {Home}